Screen changers operating procedures

Screen changers operating procedures

1. Screen changer must be in the squad or workshop technician at the same time change screen.

2. Press the remote control handle start button, start the hydraulic station.

3. After the internal pressure of the hydraulic station reaches the set pressure (at this moment, it will return to whistle reminder), press the push button or the pull button to release the push or pull button after pushing the screen changer body. Push: the screen changer below to enter the main screen changer. Pull: the top screen changer into the main screen changer.

4. Press the remote control handle stop button to close the hydraulic station.

5. Quickly clean out the net changer for swap, and remove the filter installed on the screen changer, and clean the groove to install the filter.

6. After cleaning and replacing the screen changer, install a new filter. Ready for use next time.

Batte is a professional screen changer manufacturer, supplying screen changer, especially screen changer for extrusion mould.